Agilent Technologies InfiniiVision 3000 X-Series

1048 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
35 Obsolete and Discontinued Commands
Discontinued
Parameters
Some previous oscilloscope queries returned control setting values of OFF
and ON. The InfiniiVision 3000 X- Series oscilloscopes only return the
enumerated values 0 (for off) and 1 (for on).
:POWer:SLEW:VALue none Slew rate values are now
displayed using max and min
measurements of a
differentiate math function
signal.
SYSTem:KEY none
TEST:ALL *TST (Self Test) (see page 185)
TRACE subsystem none All commands discontinued,
feature not available
TRIGger:ADVanced subsystem Use new GLITch, PATTern, or
TV trigger modes
TRIGger:TV:FIELd :TRIGger:TV:MODE (see
page 945)
TRIGger:TV:TVHFrej
TRIGger:TV:VIR none
VAUToscale none
Discontinued Command Current Command Equivalent Comments