Agilent Technologies InfiniiVision 3000 X-Series - Page 223

Root (:) Commands 6
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 223
:STOP
(see page 1138)
Command Syntax
:STOP
The :STOP command stops the acquisition. This is the same as pressing
the Stop key on the front panel.
See Also • "Introduction to Root (:) Commands" on page 190
• ":RUN" on page 219
• ":SINGle" on page 221
Example Code • "Example Code" on page 219