Agilent Technologies InfiniiVision 3000 X-Series

46 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
1 What's New
:MEASure:PPULses (see
page 435)
Counts the number of positive pulses.
:MEASure:WINDow (see
page 466)
When the zoomed time base in on, specifies whether the
measurement window is the zoomed time base or the main time
base.
:MTESt:ALL (see page 494) Specifies whether all channels are included in the mask test.
:RECall:WMEMory<r>[:STARt]
(see page 604)
Recalls reference waveforms.
:SAVE:WMEMory:SOURce
(see page 626)
Selects the source for saving a reference waveform.
:SAVE:WMEMory[:STARt]
(see page 627)
Saves reference waveforms.
:SBUS<n>:CAN Commands
(see page 652)
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:CAN subsystem.
:SBUS<n>:I2S Commands
(see page 688)
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:I2S subsystem.
:SBUS<n>:IIC Commands (see
page 707)
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:IIC subsystem.
:SBUS<n>:LIN Commands
(see page 717)
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:LIN subsystem.
:SBUS<n>:SPI Commands
(see page 652)
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:SPI subsystem.
:SBUS<n>:UART Commands
(see page 754)
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:UART subsystem.
:SEARch:EDGE Commands
(see page 782)
Commands for searching edge events.
:SEARch:GLITch Commands
(see page 785)
Commands for searching glitch events.
:SEARch:RUNT Commands
(see page 792)
Commands for searching runt events.
:SEARch:TRANsition
Commands (see page 782)
Commands for searching edge transition events.
:TRIGger:LEVel:HIGH (see
page 884)
Sets runt and transition (rise/fall time) trigger high level.
:TRIGger:LEVel:LOW (see
page 885)
Sets runt and transition (rise/fall time) trigger low level.
:TRIGger:PATTern Commands
(see
page 918)
This subsystem contains commands/functions that are in the
7000B Series oscilloscope's :TRIGger:DURation subsystem.
Command Description