ETC Cobalt 10 - OSC Commands

Cobalt 8.1 - 20181029
1032
QLab:
OSC Commands are entered as a Custom OSC Message of single text string of both the Path and the
Values (called Arguments in QLab).Values in a QLab custom OSC message are separated by spaces.
Example QLab Custom OSC Messages:
• To send the OSC Command "/cobalt/playback/3/level" with the value
0.5:/cobalt/playback/3/level 0.5
• To send the OSC Command "/cobalt/param/panTilt" with Pan value 0.5, Tilt value
0.75:/cobalt/param/panTilt 0.5 0.75
In the tables below, the example column shows this command syntax.
NOTE (7.3)
New OSC commands from 7.3 and forward starting with "/cobalt...", added
below. The old commands are still supported.
OSC Commands
Remember that OSC commands may be input differently in different softwares such as TouchOSC,
Max or Q-Lab, but the principles are the same - there is a path with one or more values, usually
expressed as numbers.
Refresh
A command to force an update of all labels and fader values
OSC path Value Example
/refreshstatus /refreshstatus
Channels
OSC Path Value Example
/cobalt/chan/select <channel #> /cobalt/chan/select 1
/cobalt/chan/add <channel #> /cobalt/chan/add 2
/cobalt/chan/subtract <channel #> /cobalt/chan/subtract 3
/cobalt/chan/thru <channel #> /cobalt/chan/thru 5
/cobalt/chan/at <level 0-100> /cobalt/chan/at 75
/cobalt/chan/wheel <increment> /cobalt/chan/wheel -2
Wheel down by 2 ticks