ETC Cobalt 10 - Example: Clear and Reset Patch

Cobalt 8.1 - 20181029
1062
Example: Clear and Reset Patch
Clear and Reset Patch is done from the Patch Wizard.
1. Select the Output tab by pressing OUTPUT
2. Open the Patch Wizard by pressing WIZARD
3. Select the Set/Clear tab with arrow keys or touch.
4. Choose action in the Operation dropdown
5. Check "Apply to all" if you want to affect the whole patch
6. Confirm with EXECUTE
7. Confirm the dialogue with OK
8. Press ESC to exit the dialogue
You can read more in Patch Introduction
.
Quit Example