ETC Cobalt 10 - Chase Step Editor - Functions

Cobalt 8.1 - 20181029
701
Chase Step Editor - Functions
The Chase can only be edited from the Chase Editor and the Chase Step Editor. This ensures that a
Chase will always play back in the way it is defined. Timing information on a step level overrides
timing information on the Chase Editor top level.
Column Action Feedback
Step Shows the number of each steps.
Step time
[#] [MODIFY]
Sets a Step time.
In
[#] [MODIFY]
Sets an In time for all steps*
Dwell
[#] [MODIFY]
Sets a Dwell time for all steps*
Out
[#] [MODIFY]
Sets a Out time for all steps*
High
[#] [MODIFY]
Sets the High level for this step, which
is applied to all channels when the step
is active.
Low
[#] [MODIFY]
Sets the Low level for this step, which is
applied to all channels when the step is
active.
Channels Displays the channels in this step.
*Times set from the Chase Editor top level are edited per step here.