ETC Cobalt 10 - Console Key - ID; Console Key - in; Console Key - INDEPENDENTS 7,8,9; Console Key - INSERT

Cobalt 8.1 - 20181029
901
Keyboard equivalent: [F5]
Console Key - ID
The ID key is used to set a temporary ID level to the selected channel(s).
• [ID] - Set the levels of the selected channel(s) temporarily to 100% for identifying.
• [#] [ID] - Set 100% to channel #
For more information see Select Channels
.
Keyboard equivalent: [-] & [+] on the numerical keypad
Console Key - IN
The IN key is used to set In times to the sequence step in the A or B field of the Main Playback
(depending on the Time Settings).
• [#] [IN] - Set an in time.
• [#] [DELAY ] & [IN] - Set a Delay In time.
For more information see Sequences - Times
, Sequence Times - Set To A or B
Keyboard equivalent: [CTRL] & [I]
Console Key - INDEPENDENTS 7,8,9
The three keys and potentiometers in the Independents area of the consoles are used to control lights
outside the main functionality of the console - for example houselights or worklights. They can
operate in three modes: Inclusive, Inhibit and Exclusive.
• [SETUP] & [independent key] - Open the settings.
• [SETUP] & [independent pot] - Hold SETUP, then move and let go of an independent
potentiometer to open the settings.
For more information see Independents
.
There is no keyboard equivalent
Console Key - INSERT
The INSERT key is used to insert new data in a list. In some lists a number is required, in some not. A
new item is usually inserted after the current item.