Cobalt 8.1 - 20181029
49
Installation guidelines
Equipment required to run this system
• Cobalt20, Cobalt10, Cobalt Nomad, Net3 RVI, Client software
• Power cables
• Up to three external DVI multi touch monitors.
• DMX512 or Ethernet cable(s) to external equipment
Connect the monitor signal cable(s) from the back of the console to the monitor(s), and then connect
the power cables to a 230/110V outlet and start all units. After approximately 30 seconds Cobalt
should be running.
See Power-up Procedure
.
To Next Page
Loading...
