Cobalt 8.1 - 20181029
324
Record a Group
Record a Group:
1. Select channels (setting levels is optional)
2. Hold RECORD and press GROUP - you will get a popup suggesting the next free group
number
3. Press MODIFY- you have now recorded a group
Use this Group to select channels:
1. Enter 0 and press CHANNEL - no channels are selected
2. Enter the number of the group you just recorded and press GROUP - these channels should
now be selected
or
1. Select GROUP as content type to a section of Direct Selects in the Direct Select tab.
2. Use the screen slider to select and bring the group up.
NOTE: If you are operating in the At Mode syntax you select a group by pressing GROUP followed
by the group number.
Assign this Group to a master:
1. Enter the number of the Group
2. Hold GROUP and press a master key. This group is now assigned to this master. If the group
has intensities stored they will apply when the master is raised. To select the channels in this
group, press the master key.
To Next Page
Loading...
