Cobalt 8.1 - 20181029
584
Control Soft Key Page - Functions
In Cobalt hardware there is no need to hold ENABLE with lamp control functions, in older hardware
the following rules apply:
Action Soft Key Feedback
Enable
[ENABLE]
This key has to be pressed
together with Lamp
On/Off/Reset to activate
them (as a safety measure).
Lamp Idle
[ENABLE] &
[Lamp_Idle]
The Device is set to it's
Lamp idle value
Lamp On
[ENABLE] &
[Lamp_On]
A lamp strike is set to the
selected channel(s)
Lamp Off
[ENABLE] &
[Lamp_Off]
A lamp off is set to the
selected channel(s)
Reset
[ENABLE] & [Reset]
A lamp reset is set to the
selected channel(s)
NOTE
These functions are Device and Template Specific. Check the manual and
template of each Device.
Control parameters are not stored in Presets.
Press HOME ATTRIB after a Lamp On/Off/Reset, or lamp idle, to avoid
sending control commands to the lights forever.
To Next Page
Loading...
