ETC Cobalt 10 - Set Channel Levels

Cobalt 8.1 - 20181029
458
Selecting Decimal Channels (7.1)
Channel RPN AT MODE
Select complete device
[1] [CHANNEL] [1]
Select only base channel
[1] [.] [0]
[CHANNEL]
[1] [.] [0]
Select only decimal
channels
[1] [.] [1]
[CHANNEL]
[1] [.] [1]
Invert base/decimal
[INVERT] & [.] [INVERT] & [.]
Set Channel Levels
Once a channel(s) is selected you can set levels in the following ways.
Level Command RPN AT MODE
Set to 50%
[5] [0]
[@LEVEL]
[@LEVEL] [5] [0]
Set to 55%
[5] [5]
[@LEVEL]
[@LEVEL] [5] [5]
Set to 100%
[@LEVEL]
[@LEVEL]
[@LEVEL] [@LEVEL]
Set to 70%*
[@LEVEL] [@LEVEL] [7] [0]
Set to 0%
[@LEVEL]
[@LEVEL]
[@LEVEL]
[@LEVEL] [0]
Set to 0%
[C/Alt] &
[
-
%] [C/Alt] &
[
-
%]
Add 5%
[+%] [+%]
Subtract 5%
[
-
%]
[
-
%]
Select ch # and add 5%
[#] [+%] [#] [+%]
Select ch # and subtract 5%
[#]
[
-
%] [#]
[
-
%]
Increase level by #%
[#] [.] [+%]
not possible in at mode
Diminish level by #%
[#] [.]
[
-
%]
not possible in at mode
Revert to last used level
(Undo)
[ON/FETCH] &
[@LEVEL]
[ON/FETCH] & [@LEVEL]