Cobalt 8.1 - 20181029
773
Main Playback - Manual Crossfades
Move the crossfaders from the down position to the up position to perform a manual crossfade. When
both reach the top position the crossfade is terminated and the next sequence step is advanced. (See
Main Playback - Introduction
).
General Facts
• Take over timed fades manually.
• Press GO during a manual fade.
• Set the crossfaders to fade in both directions in the Settings for the Playback (Hold SETUP
and press PLAYBACK).
• When you make a manual crossfade to a step with attributes, the attribute values that are
GoOnGo will follow the movement of the B-fader.
• You can record the actual manual movement of the crossfaders using a Crossfade Profile. See
Sequences - Crossfade Profiles
To Next Page
Loading...
