Cobalt 8.1 - 20181029
644
Device Times - Individual or FCB
Device times can be set to individual parameter of selected devices, or to a parameter group like
Focus, Color or Beam for all devices in the preset.
FCB times are defaulted to run in 100% of the main In and Delay times for a step. You can change
this percentage or set an absolute time in seconds. An individual parameter time always wins over a
general FCB time.
Times are shown in the playback view. Individual parameter times are shown as a red dot at the end of
FCB timelines - See Color in the example below.
Setting times in the advanced recording popup
You can set these times directly in the Advanced tab of the Recording Popup
when you record a new
preset.
To Next Page
Loading...
