ETC Cobalt 10 - Play Settings - Introduction

Cobalt 8.1 - 20181029
198
Play Settings - Introduction
Press SETUP in the programming section to open system settings. You can also open a local settings
popup for any key by holding SETUP and pressing that key (for example GO or RECORD)
The system settings popup contains the following sections
• LETS BEGIN
>A summary of the most important settings.
• CHANNELS
>Configure default values and select Command Syntax.
• CROSSFADE
>Configure default times, fader modes and fade direction.
• MASTERS
>Configure Flash and fade on time and Auto-save master pages.
• EFFECTS
>Configure "Remember Effect Parameters".
• SYSTEM
>Configure Auto-save, rubberband, beep, remote etc.
• ATTRIBUTES
>Configure default times and recording modes.
• MIDI
>Midi Settings
• SHOW CONTROL
>Configure Midi, Show Control and Time Code.