ETC Cobalt 10 - Active Mode & Mark; Active Mode & Attribute Tracking

Cobalt 8.1 - 20181029
614
All commands are executed to the currently selected Devices.
Function Key Feedback
Set all parameters to
changed
[Set_Chnged] &
[PALETTE]
All parameters are flagged
as changed (purple
background).
Set Focus parameters to
changed
[Set_Chnged] &
[FOCUS]
Focus parameters are
flagged as changed (purple
background).
Set Color parameters to
changed
[Set_Chnged] &
[COLOR]
Color parameters are
flagged as changed (purple
background).
Set Beam parameters to
changed
[Set_Chnged] &
[BEAM]
Beam parameters are
flagged as changed (purple
background).
Set a specific parameter to
changed
[Set_Chnged] &
[Wheel_Key]
Specific parameters are
flagged as changed (purple
background).
The changed device indication is cleared when you fade or step in the Sequence.
See Channel Information - Detailed
For more information see Presets - Record
Active Mode & Mark
Active Mode (default) means that all devices with an intensity over 0% will be recorded with all
parameters.
To be able to record parameters when an intensity is at 0% there is a special intensity state called
"Mark" which is indicated with an "M" where the level is normally shown.
To set a Mark level, select the channels press MARK.
Active Mode & Attribute Tracking
This is a mode that is automatically set to ON when you select Active mode for recording attributes
(5.1).