Cobalt 8.1 - 20181029
990
Number entry after [@Level] is a two digit entry. If you only enter one number, you can press [C/Alt
to end level entry.
NOTE
When RECORDING only levels from the remote are recorded, not the whole
stage output.
Transmitter Setup
The transmitter unit has a slide switch (on/off) and 16 keys for console commands. The unit has a
“sleep” feature that helps to conserve battery life when the switch is left in the “on” position. Set the
switch to the “off” position to guard against accidental key presses.
The keys of the transmitter unit are illuminated. The keys are brightly lit while keys are pressed and
the unit is transmitting. After the key is released, the keys remain dimly lit for a period of time before
the unit sleeps. The sleep delay can be programmed at the transmitter unit as described below.
Set the transmitter unit sleep delay
Step 1: Move the slide switch to the “off” position.
Step 2: Press and hold
• [FUNC] for a 5 second sleep delay.
• [THRU] for a 12 second sleep delay.
• [Ch] for a 25 second sleep delay.
• [@ Level] for no sleep delay (the unit does not turn off).
Step 3: While pressing one of the keys above, slide the switch to the “on” position and wait until the
keys are blinking (about 5 seconds).
Step 4: Release the key you are pressing. The sleep delay time is now programmed to the setting you
selected above.
Replacing the transmitter battery
The transmitter unit requires a single 9V alkaline battery (provided) for power. This battery should
provide approximately one year of normal usage before requiring replacement. To replace the battery,
remove the two M3x4mm screws at the bottom of the unit to access the battery compartment and
replace with a 9V alkaline battery. Replace the lid and secure it with the same two screws. Dispose of
the old battery as is appropriate in your local area.
To Next Page
Loading...
