Cobalt 8.1 - 20181029
989
Function Key Feedback
[100%]
full
Set to 0%
[FUNC] [0%]
Levels for the selected channels are set to
zero
Set to level
[#]
[@Level]
Level # is set for selected channels
Increase/decrease
levels
[FUNC] [+%]
[FUNC] [-%]
Levels for the selected channels are changed
up/down. Hold the [+%] or [-%] keys to
have the channel fade up/down.
Check mode
[FUNC]
[Check+]
[FUNC]
[Check-]
Steps to the next/last channel using the level
See Check mode (add link to "Channels -
Check Mode" chapter)
GO
[FUNC]
[Go/Goto]
Next crossfade is started
GO Back
[FUNC] [Go
Back]
Crossfades to the previous step
GOTO a
preset/step
[#] [FUNC]
[Go/Goto]
Crossfades to preset # or step # (depending
on the GOTO jumps to setting in Setup)
Record preset
[#] [FUNC]
[Record]
Records Preset # into the Preset List. Only
the levels set from the remote are recorded
Update
[Update]
Updates the preset that was last activated
from the remote
Load levels from
Preset
[#] [FUNC]
[Preset]
Levels from Preset # are loaded into A
Clear number input
[C/Alt
Clears numbers input
Clear remote field
[FUNC] [All]
[FUNC]
[0%]
Clears all channels turned on from remote
Using Check mode from channel 1 onward:
[1] [FUNC] [100%] then [FUNC] [Check+] then [FUNC] [Check+]
At Mode
If a console is set to work in At Mode, channel selection functions on the remote behave differently.
For example:
• Set channels 1 thru 5 to 55%: [1] [THRU] [5] [@Level] [5] [5]
• Set channels 11 thru 14 at full: [11] [THRU] [14] [FUNC] [100%]
To Next Page
