ETC Cobalt 10 - Select Channels

Cobalt 8.1 - 20181029
457
Select Channels
The fastest way to select a channel and set a level regardless of syntax is to enter the number of that
channel and move the level wheel.
This is a table with the key entries for most channel commands. See also Multicell Devices
.
Channel RPN AT MODE
Clear selected channels
[C/Alt] [C/Alt] [C/Alt] & [C/Alt]
Select channel 1
[1] [CHANNEL] [1]
Add channel 2
[2] [+] [+] [2]
Add through 7
[7] [THRU] [THRU] [7]
Subtract ch 3
[3]
[
-
]
[
-
]
[3]
Select all channels with a
level in the channel
control
[ALL] [ALL]
Select all channels at
level # in the channel
control
# [ALL] & [@LEVEL] # [ALL] & [@LEVEL]
Select all channels with a
level in any playback
[ALL] [ALL] [ALL] [ALL]
Invert the current channel
selection (of all channels
with a level)
[INV_GROUP] [INV_GROUP]
Step to the next ch
[+] [+]
Step to the previous ch
[
-
]
[
-
]
NOTE
To complete a channel selection in At Mode without pressing the @ LEVEL
key. use the decimal [.] key twice.
See Channels - Clear Functions