Cobalt 8.1 - 20181029
728
Dynamics - Base Value
When a Dynamic Effect is activated, it will run with the current position of the corresponding attribute
or intensity as a Base Value.
If you change this Base Value, the Dynamic Effect will follow. If you run a Preset with a Dynamic
Effect and then run another Preset with a new base value, the default action is for the Dynamic Effect
to fade out. Use the Keep Dynamics setting to allow the Dynamic Effect to play through Presets. See
Record Keep Dynamics
.
If a pan/tilt effect such as Circle is running for a moving Device, you can change the Base Value by
moving Pan and Tilt, or by selecting a Focus Palette.
NOTE
If the Base Value is too small, some effects will not be visible, for example
color mix and intensity effects. Set the Base Value to 50% for maximum
effect.
To Next Page
Loading...
