ETC Cobalt 10 - Select Channels from Effect

Cobalt 8.1 - 20181029
681
At mode syntax
If your Cobalt is set to use At Mode for channel commands, effects are selected in the following ways.
You can terminate a selection in At Mode pressing @Level or the decimal point.
Action Key Feedback
Select effect
[EFFECT] [#]
Effect # is selected
Add an effect
[+] [EFFECT] [#]
Effect # is added to the
current selection
Subtract an effect
[
-
]
[EFFECT] [#]
Effect # is subtracted from
the current selection
Add multiple effects
[THRU] [#]
Up to effect # is added to
the current selection
Add a channel
[+] [CHANNEL] [#]
Channel # is added to the
current selection
Add a group
[+] [GROUP] [#]
Effect # is added to the
current selection
Subtract a channel
[
-
]
[CHANNEL] [#]
Channel # is subtracted
from the current selection
Subtract a group
[
-
]
[GROUP] [#]
Effect # is subtracted from
the current selection
Select channels from effect
These functions make it possible to select channels involved in an effect.
Action Key Feedback
Select active channels
[EFFECT] &
[CHANNEL]
All channels involved in effects
that are active are selected.
Select all in effect...
[#] [EFFECT] &
[CHANNEL]
All channels involved in effect
playback # are selected.
Select active effects
[EFFECT] & [ALL]
or
[ALL] & [EFFECT]
All active effect playbacks are
selected. Pressing ALL alone
will never select effect
playbacks.
Toggle between
selecting an effect and
the channels assigned
to it.
[Inv_Eff/Ch]
or
[C/Alt] & [INV
GROUP]
The soft key Inv Eff/Ch in the
Effects soft key meny allow
you to toggle the channel
selection between the selected
effect playback and the
channels assigned to it.