ETC Cobalt 10 - Output Editor - Patch by Channel

Cobalt 8.1 - 20181029
263
Output Editor - Patch By Channel
As soon as a channel is selected, the Output Editor is automatically in channel mode. Select a single
channel or a range of channels to patch to Outputs. Use 0 MODIFY to unpatch.
Patch a single channel
Action Key Feedback
1. Select channel
[#] [CHANNEL]
Channel is selected.
2. Patch to output
[#] [MODIFY]
A popup will ask if you
want to replace existing
output(s)*
3. Confirm
[MODIFY]
Patch is complete.