ETC Cobalt 10 - Console Key - RANGE; Console Key - REM DIM; Console Key - RECORD

Cobalt 8.1 - 20181029
916
There is no keyboard equivalent.
Console Key - RANGE
Hold the RANGE key and select which part of the fader range 1-80 you want to control with the
master playbacks, from the keys over and under the display.
• [RANGE] (held) - allows you to select which bank from the fader range 1-80 yo wish to
assig to the physcial faders.
• [#] [RANGE] & [Master key] - assigns the range in which this master exists.
For more information see Masters - Select Playback Range
No keyboard equivalent
Console Key - REM DIM
The REM DIM key is part of the channel select and level keys. It is used to set all channels in the A
field to zero except the current selection. It can be set to perform the BALANCE function as well
which holds the cleared levels in a temporary memory bank.
• [REM DIM] - Set all channels except the current selection to zero.
• [SETUP] & [REM DIM] - Opens settings for this key.
If set to Balance Mode:
Press REM DIM to activate Balance mode and set all channels except the current selection to zero.
Press REM DIM again to bring them back at their previous levels.
For more information see Channels - Rem Dim
, Channels - Balance Mode.
There is no keyboard equivalent
Console Key - RECORD
The RECORD key is fundamental in that it is used for recording all types of data into Presets, Groups
and Palettes.What is recorded depends on your Settings, where you are recording, and what your
record target is.
In Live:
• [RECORD] - Opens the recording dialogue to record the current look on stage into the next
free Preset.
• [#] [RECORD] - Opens the recording dialogue to record the current look on stage into that
Preset..
• [RECORD] [ATTRIB] - Record all attributes for the currently selected channels to the Preset
in the A field of the main playback.