Cobalt 8.1 - 20181029
298
Templates - Type LTP or HTP
Each parameter in a Template can be set to LTP (Latest Takes Precedence) or HTP (Highest Takes
Precedence).
• HTP8 is used for 8 bit intensity parameters
• HTP16 is used for 16 bit intensity parameters*
• LTP8 is used for 8 bit parameters
• LTP16 is used for 16 bit parameters*
This is set in the Template Editor.
See Device Templates - Editor
.
*Observe that the DMX offset of a parameter has to be incremented by 2, if the previous parameter is
set to 16-bit resolution.
See Device Templates - 16 bit Control
To Next Page
