Cobalt 8.1 - 20181029
179
• ArtNet
- Check this feature if you are using devices or nodes receiving ArtNet.
Address: Choose network and IP address if more than one is available.
Enable Output in Offline Mode
In Offline Mode output will be sent at a slower than normal pace to enable the use of external
vizualisers.
NOTE
When the software is started in Offline mode there is no DMX output unless
the output box is checked.
Network - Interface Protocols
• ACN (E1.17)
This needs to be enabled if you have units with bi-directional communication, like for
example the Net3 I/O Gateway. This also includes Net3 DMX/RDM Gateways because the
RDM communication is passed via ACN to the console.
ACN has to be enabled for:
o Sensor+ dimmer feedback
o Sensor3 power control system feedback
o RDM via ETC Net3 Gateways
o Net3 Show Control Gateways
o Net3 I/O Gateways
o Net3 RFR (the steel one)
o DMX Input via sACN
• FDX2000 Feedback
Error reporting for the FDX2000 dimming system
• Dimstat Feedback
Activates Dimstat feedback.
• WIFI Remote
Activate to use iRFR Classic and aRFR Classic
• UDP Strings
Sets the network card for UDP Strings. See Play Settings - Show Control
.
To Next Page
Loading...
