Cobalt 8.1 - 20181029
716
It is the combination of the parts distribution and the step timing that creates
the overlapping ripple behavior. If the Attack+Sustain+Decay time is greater
than the step time, you get ripple (overlapping) behavior. The number of
Parts in the Channel Source will define how "wide" the ripple is.
Content Effect Times
Timing information is set in two levels
• In the Series List
• In the Series Step Editor
In the Series list, the default times are
• Default Step Time
• Default Attack Time
• Default Sustain Time (Break mode only)
• Default Release Time (Break mode only)
See Series List
.
In the Series Step editor, the times are
• Step Time
• Attack Time (separate for Intensity and each content 1-3 in each step)
• Sustain Time (Break mode only) per step
• Release Time (Break mode only) per step
See Series Step Editor
.
To Next Page
Loading...
