Cobalt 8.1 - 20181029
642
If the FCB Times are set to 50% of the IN-time they will be 2.5 seconds at an in time of 5 seconds.
If the In-time is changed to 10 seconds, the FCB-times will be 50% of 10 (= 5 seconds).
NOTE
In Congo plays files earlier than Version 4.2, the FCB Delay time was set to
100% due to the fact that Delay Times were inherited from the Delay In
time. These plays (pre-4.2) with FCB Delays set to 100% will be converted to
use a delay of 0s instead.
Default Attribute Time
The Default Attribute Time (3 seconds) is used mainly to keep noise and unnecessary mechanical
friction down when a Moving Device is positioned in the following situations:
• When attributes are executed from Independents
• When copying Blind attributes to Live
• When using Stop table for an old dynamic
• When you press Home Attributes
• When jumping in the sequence
• Using REFRESH in the Main Playback
To Next Page
Loading...
