Cobalt 8.1 - 20181029
212
Function Explanation Default value
Direct mode Midi Direct Mode On
MIDI Channel The MIDI channel used by Cobalt 1
Keys All keys are sent as notes. Off
Faders All faders are sent as controllers. Off
Program Change Jumps to sequence step # -
MIDI Show control
Cobalt supports sending and receiving of MIDI Show Control (MSC) commands. See MIDI - MIDI
Show Control.
Function Explanation Default value
Active Activates reception of MSC. Off
Device ID Sets a Device ID for this Cobalt. 1
Time Code
Every sequence step can be triggered both manually, and by a specific MIDI Time Code time on the
MIDI port. See MIDI - Time Code
.
Function Explanation Default value
Time Code MIDI Times Code reception is on. Off
Learn mode Activate learn mode for setting
Time Code to Sequence Steps.
Off
Auto-locate step Sets if Time Code should auto-
locate steps or not.
Off
Enable Backup clock Enables the backup clock Off
Internal clock start Sets a start time for the internal
clock.
--.--.--.--
To Next Page
Loading...
