Cobalt 8.1 - 20181029
994
In Capture Argo, each protocol can have its own IP address selection. Be sure to set the proper IP
address for each of the protocols that you are using.
A valid network link is required to receive sACN, even if the source is another application on the
same PC.
This means a standalone PC will require either an active connection to an ethernet switch or the
"Loopback Adapter" to be installed.
Following a restart, open your existing project or start a new one.
In the Project Window, you will see a tab showing Universes. You should see both BSR E1.31 and
ETCNet2 Universes, assuming you have any dimmers patched on your console.
To Next Page
