Agilent Technologies InfiniiVision 3000 X-Series - Page 140

140 Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
4 Commands Quick Reference
:TIMebase:WINDow:RANG
e <range_value> (see
page 874)
:TIMebase:WINDow:RANG
e? (see page 874)
<range value> ::= range value in
seconds in NR3 format for the
zoomed window
:TIMebase:WINDow:SCAL
e <scale_value> (see
page 875)
:TIMebase:WINDow:SCAL
e? (see page 875)
<scale_value> ::= scale value in
seconds in NR3 format for the
zoomed window
Table 48 :TIMebase Commands Summary (continued)
Command Query Options and Query Returns
Table 49 General :TRIGger Commands Summary
Command Query Options and Query Returns
:TRIGger:FORCe (see
page 880)
n/a n/a
:TRIGger:HFReject {{0
| OFF} | {1 | ON}}
(see page 881)
:TRIGger:HFReject?
(see page 881)
{0 | 1}
:TRIGger:HOLDoff
<holdoff_time> (see
page 882)
:TRIGger:HOLDoff?
(see page 882)
<holdoff_time> ::= 60 ns to 10 s
in NR3 format
:TRIGger:LEVel:ASETup
(see page 883)
n/a n/a
:TRIGger:LEVel:HIGH
<level>, <source>
(see page 884)
:TRIGger:LEVel:HIGH?
<source> (see
page 884)
<level> ::= .75 x full-scale
voltage from center screen in NR3
format.
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels)
in NR1 format
:TRIGger:LEVel:LOW
<level>, <source>
(see page 885)
:TRIGger:LEVel:LOW?
<source> (see
page 885)
<level> ::= .75 x full-scale
voltage from center screen in NR3
format.
<source> ::= CHANnel<n>
<n> ::= 1 to (# analog channels)
in NR1 format
:TRIGger:MODE <mode>
(see page 886)
:TRIGger:MODE? (see
page 886)
<mode> ::= {EDGE | GLITch |
PATTern | TV | DELay | EBURst |
OR | RUNT | SHOLd | TRANsition |
SBUS{1 | 2} | USB}
<return_value> ::= {<mode> |
<none>}
<none> ::= query returns "NONE"
if the :TIMebase:MODE is ROLL or
XY