H3C S3600 Series User Manual

Operation Manual – VLAN
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
VLAN Overview
1-7
Encapsulation
Protocol
Ethernet II 802.3 raw
802.2
LLC
802.2
SNAP
Type
value
AppleTalk Supported
Not
supported
Not
supported
Supporte
d
0x809B
1.3.5 Implementation of Protocol-Based VLAN
S3600 series Ethernet switches assign the packet to the specific VLAN by matching the
packet with the protocol template.
The protocol template is the standard to determine the protocol to which a packet
belongs. Protocol templates include standard templates and user-defined templates:
z The standard template adopts the RFC-defined packet encapsulation formats and
values of some specific fields as the matching criteria.
z The user-defined template adopts the user-defined encapsulation formats and
values of some specific fields as the matching criteria.
After configuring the protocol template, you must add a port to the protocol-based
VLAN and associate this port with the protocol template. This port will add VLAN tags to
the packets based on protocol types. The port in the protocol-based VLAN must be
connected to a client. However, a common client cannot process VLAN-tagged packets.
In order that the client can process the packets out of this port, you must configure the
port in the protocol-based VLAN as a hybrid port and configure the port to remove
VLAN tags when forwarding packets of all VLANs.
 Note:
For the operation of removing VLAN tags when the hybrid port sends packets, refer to
the section “Port Basic Configuration” in this manual.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English