H3C S3600 Series User Manual

Operation Manual – Information Center
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Information Cente
r
1-12
 Note:
To view debugging information of specific modules, you need to set the information
type as debug in the info-center source command, and enable debugging on
corresponding modules with the debugging command as well.
1.2.7 Enabling Information Output to the SNMP
Table 1-12 lists the related configurations on the switch.
Table 1-12 Enable information output to the SNMP
Operation Command Description
Enter system view
system-view
—
Enable the
information center
info-center enable
Optional
By default, the information
center is enabled.
Enable information
output to the
SNMP
info-center snmp channel
{ channel-number |
channel-name }
Required
By default, the switch outputs
trap information to SNMP
through channel 5.
Define an
information source
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap
| debug } { level severity |
state state } ]*
Required
Set the format of
time stamp
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Optional
This is to set the time stamp
format for log/debugging/trap
information output.
This determines how the time
stamp is presented to users.
 Note:
z To view debug information of specific modules, you need to set the information type
as debug in the info-center source command, and enable debugging on
corresponding modules with the debugging command as well.
z To send information to a remote SNMP workstation properly, related configurations
are required on both the switch and the SNMP workstation.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English