H3C S3600 Series User Manual

Operation Manual – Auto Detect
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2
Auto Detect Implementation
2-3
[H3C-detect-group-8] detect-list 1 ip address 10.1.1.4 nexthop 192.168.1.2
[H3C-detect-group-8] quit
# Enable the static route when the detecting group is reachable. Disable the static route
when the detecting group is unreachable.
[H3C] ip route-static 10.1.1.4 24 192.168.1.2 detect-group 8
2.3 Auto Detect Implementation in VRRP
 Note:
Currently, auto detect implementation in VRRP is only supported on S3600-EI series
switches.
You can control the priorities of VRRP backup groups according to auto detect results
to enable automatic switch between the master and the backup switch as follows:
z Decrease the priority of a VRRP backup group when the result of the detecting
group is unreachable.
z Resume the priority of a VRRP backup group when the result of the detecting
group is reachable.
2.3.1 Configuring the Auto Detect Function for VRRP
 Note:
You need to create the detecting group and perform VRRP-related configurations
before the following operations.
Table 2-2 Configure the auto detect function for VRRP
Operation Command Description
Enter system view
system-view
—
Enter VLAN
interface view
interface vlan-interface vlan-id
—
Enable the auto
detect function for
VRRP
Vrrp vrid virtual-router-id track
detect-group group-number
[ reduced value-reduced ]
Required

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English