Operation Manual – PoE-PoE Profile
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
PoE Configuration
1-4
Caution:
By default, the PoE function on a port is enabled by the default configuration file when
the device is delivered.
If you delete the default configuration file without specifying another one, the PoE
function on a port will be disabled after you restart the device..
1.4 Setting the Maximum Output Power on a Port
The maximum power that can be supplied by a PoE-enabled S3600 switch to its PD is
15,400 mW. In practice, you can set the maximum power on a port depending on the
actual power of the PD, in the range of 1,000 to 15,400 mW and in the granularity of 100
mW.
Table 1-3 Set the maximum output power on a port
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Set the maximum output
power on the port
poe max-power
max-power
Required
By default, the
maximum output
power on a port is
15,400 mW
1.5 Setting PoE Management Mode and PoE Priority of a Port
The power supply management mode and the port priority settings will work together to
control the power feeding of the switch when the switch PoE is close to its full power
load.
When AC power input is adopted for the switch, the maximum total power that can be
supplied by the PoE-enabled S3600 switch is 300 W. By default, when the switch PoE
reaches its full load in supplying power, it will manage the power supply to its ports in
auto mode.
z auto mode: When the switch is close to its full load in supplying power, it will first
supply power to the PDs that are connected to the ports with critical priority, and
then supply power to the PDs that are connected to the ports with high priority. For
example: Port A has the priority of critical. When the switch PoE is close to its full
load and a new PD is now added to port A, the switch will power down the PD
To Next Page
Loading...
Need help?
General