H3C S3600 Series User Manual

Operation Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 8 MSDP Configuration
8-10
Operation Command Description
Create an MSDP peer
connection
peer peer-address
connect-interface
interface-type
interface-number
Required
Configure the RP address
to be carried in SA
messages
originating-rp
interface-type
interface-number
Required
By default, the RP
address in SA messages
is the RP address
configured by PIM.
 Note:
In Anycast RP application, C-BSR and C-RP must be configured on different devices or
ports.
8.3.4 Configuring an MSDP Mesh Group
Configure a mesh group name on all the peers that will become members of the MSDP
mesh group so that the peers are fully connected with one another in the mesh group.
Table 8-5 Configure an MSDP mesh group
Operation Command Description
Enter system view
system-view
—
Enter MSDP view
msdp
—
Add an MSDP peer to a
mesh group
peer peer-address
mesh-group name
Required
This command must be
configured on all the
peers; therefore, you
need to configure this
command for multiple
times.
 Note:
z Before you configure an MSDP mesh group, make sure that the routers are fully
connected with one another.
z The same group name must be configured on all the peers.
z If you add the same MSDP peer to multiple mesh groups, only the latest
configuration takes effect.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English