H3C S3600 Series User Manual

Operation Manual – QoS-QoS Profile
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
QoS Configuration
1-14
Operation Command Description
Set the port priority
priority priority-level
Optional
By default, the port
priority is 0
Table 1-7 Set to use the packet priority
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port
view
interface interface-type
interface-number
—
Set the switch to use
the packet priority
priority trust
Through this
configuration, the switch
uses the packet priority
instead of the port priority
III. Configuration example
z Set to use the port priority and specify the priority of Ethernet1/0/1 to 7.
Configuration procedure:
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] interface Ethernet1/0/1
[H3C-Ethernet1/0/1] undo priority
[H3C-Ethernet1/0/1] priority 7
z Set the switch to use the 802.1p priority carried in the packet on Ethernet1/0/1.
Configuration procedure:
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] interface Ethernet1/0/1
[H3C-Ethernet1/0/1] priority trust
1.5 Configuring Priority Remark
Refer to section 1.1.5 "Priority Remark" for the introduction to priority remark.
Priority remark can be implemented in the following ways:
z Through TP. When configuring TP, you can define the action of remarking the
DSCP precedence of the packets out of the traffic limit. Refer to section
1.8.2
"Configuration Procedure of TP".
z Through the traffic-priority command. You can remark the IP precedence, 802.1p
precedence, DSCP precedence, and local precedence of the packets.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English