H3C S3600 Series User Manual

Operation Manual – DHCP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2
DHCP Server Configuration
2-28
III. Configuring the option 184 supporting function in global DHCP address
pool view
Table 2-26 Configure the option 184 supporting function in global DHCP address pool
view
Operation Command Description
Enter system view
system-view
—
Configure the interface to
operate in DHCP server
mode and assign the IP
addresses of a global
address pool to DHCP
clients
dhcp select global { all | interface
interface-type interface-number [ to
interface-type interface-number ] }
Required
Enter DHCP address pool
view
dhcp server ip-pool pool-name
—
Configure an IP address
range IP addresses in
which are dynamically
assigned
network ip-address [ mask netmask ] —
Configure the NCP-IP
sub-option
voice-config ncp-ip ip-address
Required
Configure the AS-IP
sub-option
voice-config as-ip ip-address
Optional
Configure the voice VLAN
configuration sub-option
voice-config voice-vlan vlan-id
{ enable | disable }
Optional
Configure the Fail-over
call routing sub-option
voice-config fail-over ip-address
dialer-string
Optional
 Note:
Perform the operations listed in Table 2-26 in global address pool view if you specify to
assign IP addresses of a global DHCP address pool to DHCP clients.
2.6.4 Configuration Example
I. Network requirements
A 3COM VCX device operating as a DHCP client requests the DHCP server for all
sub-options of option 184. A H3C series switch operates as the DHCP server. The
option 184 supporting function is configured for a global DHCP address pool. The
sub-options of option 184 are as follows:
z NCP-IP: 3.3.3.3

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English