H3C S3600 Series User Manual

Operation Manual – Information Center
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Information Cente
r
1-6
1.2.2 Enabling Information Output to a Log Host
Table 1-5 lists the related configurations on the switch.
Table 1-5 Enable information output to a log host
Operation Command Description
Enter system view
system-view
—
Enable the
information center
info-center enable
Optional
By default, the information center
is enabled.
Enable information
output for a
specified switch in
a fabric
info-center switch-on
{ unit unit-id | master |
all } [ debugging |
logging | trapping ]*
By default, debugging
information output is enabled,
and log and trap information
output are disabled for the
master switch in a fabric.
Debugging, log and trap
information output are all
disabled for other switches in the
fabric.
Enable information
output to a log host
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number | language
{ chinese | english } ]*
Required
By default, the switch does not
output information to the log host.
After you configure the switch to
output information to the log host,
the switch uses information
channel 2 by default.
Be sure to set the correct IP
address. A loopback IP address
will cause an error message
prompting that this address is
invalid.
Configure the
source interface
through which log
information is sent
to the log host
info-center loghost
source interface-type
interface-number
Optional
Define an
information source
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
Required
Set the format of
the time stamp to
be sent to the log
host
info-center timestamp
loghost { date |
no-year-date | none }
Optional

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English