Operation Manual – SNMP-RMON
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
SNMP Configuration
1-9
Table 1-6 Display SNMP
Operation Command Description
Display the SNMP
information about the
current device
display snmp-agent sys-info
[ contact | location | version ]*
Display SNMP packet
statistics
display snmp-agent statistics
Display the engine ID of
the current device
display snmp-agent
{ local-engineid |
remote-engineid }
Display group
information about the
device
display snmp-agent group
[ group-name ]
Display SNMP user
information
display snmp-agent usm-user
[ engineid engineid | username
user-name | group group-name ]
Display Trap list
information
display snmp-agent trap-list
Display the currently
configured community
name
display snmp-agent community
[ read | write ]
Display the currently
configured MIB view
display snmp-agent mib-view
[ exclude | include | viewname
view-name ]
These commands
can be executed
in any view.
1.6 SNMP Configuration Example
1.6.1 SNMP Configuration Example
I. Network requirements
z An NMS and Switch A are connected through the Ethernet. The IP address of the
NMS is 10.10.10.1 and that of the VLAN interface on Switch A is 10.10.10.2.
z Perform the following configuration on Switch A: setting the community name and
access permission, administrator ID, contact and switch location, and enabling the
switch to sent trap packets.