H3C S3600 Series User Manual

Operation Manual – Link Aggregation
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Link Aggregation Configuration
1-11
You need to enable LACP on the ports which you want to participate in dynamic
aggregation of the system, because, only when LACP is enabled on those ports at both
ends, can the two parties reach agreement in adding/removing ports to/from dynamic
aggregation groups.
 Note:
You cannot enable LACP on a port which is already in a manual aggregation group.
Table 1-3 Configure a dynamic LACP aggregation group
Operation Command Description
Enter system view
system-view
—
Configure a description
for an aggregation group
link-aggregation group
agg-id description
agg-name
Optional
By default, an
aggregation group has no
description.
Configure the system
priority
lacp system-priority
system-priority
Optional
By default, the system
priority is 32,768.
Enter Ethernet port view
interface interface-type
interface-number
—
Enable LACP on the port
lacp enable
Required
By default, LACP is
disabled on a port.
Configure the port priority
lacp port-priority
port-priority
Optional
By default, the port priority
is 32,768.
1.3 Displaying and Maintaining Link Aggregation
Configuration
After the above configuration, execute the display command in any view to display the
running status after the link aggregation configuration and verify your configuration.
Execute the reset command in user view to clear LACP statistics on ports.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English