H3C S3600 Series User Manual

Operation Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 7 PIM Configuration
7-19
 Note:
When you execute the spt-switch-threshold command on an S3600 Ethernet switch,
the traffic-rate argument can only be set to 0. That is, the threshold can be set to 0 or
infinity.
z With the threshold set to 0, the last hop switch switches to SPT once it receives the
first multicast packet.
z With the threshold set to infinity, the last hop switch never switches to SPT.
7.5 Displaying and Debugging PIM
After completing the above-mentioned configurations, you can execute the display
command in any view to verify the configuration by checking the displayed information.
Table 7-12 Display and maintain PIM
Configuration Command Description
Display PIM multicast
routing tables
display pim routing-table
[ { { *g [ group-address [ mask
{ mask-length | mask } ] ] | **rp
[ rp-address [ mask
{ mask-length | mask } ] ] } |
{ group-address [ mask
{ mask-length | mask } ] |
source-address [ mask
{ mask-length | mask } ] } * } |
incoming-interface
{ interface-type
interface-number | null } |
{ dense-mode |
sparse-mode } ] *
Display the information
about PIM interfaces
display pim interface
[ interface-type
interface-number ]
Display the information
about PIM neighbor
routers
display pim neighbor
[ interface interface-type
interface-number ]
Display BSR information
display pim bsr-info
Display RP information
display pim rp-info
[ group-address ]
You can execute
the display
command in any
view.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English