H3C S3600 Series User Manual

Operation Manual – Login
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 3
Logging in through Telnet
3-13
Scenario
Authenticati
on mode
User type Command
Command
level
The user privilege level level
command is executed, and the
service-type command specifies
the available command level.
The user privilege level level
command is not executed, and
the service-type command does
not specify the available
command level.
Level 0
The user privilege level level
command is not executed, and
the service-type command
specifies the available command
level.
Determined
by the
service-typ
e command
The user privilege level level
command is executed, and the
service-type command does not
specify the available command
level.
Level 0
VTY users that
are
authenticated
in the
password
mode of SSH
The user privilege level level
command is executed, and the
service-type command specifies
the available command level.
Determined
by the
service-typ
e command
 Note:
Refer to the corresponding modules in this manual for information about AAA, RADIUS,
and SSH.
3.4.2 Configuration Example
I. Network requirements
Assume the switch is configured to allow you to login through Console, and your user
level is set to the administrator level (level 3). After you login through Console, you
need to limit the telnet user into VTY 0 at the following aspects.
z Configure the name of the local user to be “guest”.
z Set the authentication password of the local user to 123456 (in plain text).
z Set the service type of VTY users to Telnet.
z Configure to authenticate users logging into VTY 0 in scheme mode.
z The commands of level 2 are available to users logging into VTY 0.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English