H3C S3600 Series User Manual

Operation Manual – MSTP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
MSTP Configuration
1-44
1.8.2 Configuring VLAN-VPN tunnel
Table 1-39 Configure VLAN-VPN tunnel
Operation Command Description
Enter system view
system-view
—
Enable MSTP globally
stp enable
—
Enable the VLAN-VPN
tunnel function globally
vlan-vpn tunnel
Required
Enter Ethernet port view
interface
interface-type
interface-number
Make sure that you enter the
Ethernet port view of the port for
which you want to enable the
VLAN-VPN tunnel function.
Disable MSTP for the port
stp disable
—
Enable the VLAN VPN
function for the Ethernet
port
vlan-vpn enable
Required
By default, the VLAN VPN
function is disabled on all ports.
 Note:
z The VLAN-VPN tunnel function can be enabled on only STP-enabled devices.
z To enable the VLAN-VPN tunnel function, make sure the links between operator’s
networks are trunk links.
z If a fabric port exists on a switch, you cannot enable the VLAN VPN function on any
port of the switch.
1.9 Displaying and Maintaining MSTP
You can verify the above configurations by executing the display commands in any
view.
Execute the reset command in user view to clear statistics about MSTP.
Table 1-40 Display and maintain MSTP
Operation Command
Display the state and statistics
information about spanning trees of the
current device
display stp [ instance instance-id ]
[ interface interface-list | slot
slot-number ] [ brief ]
Display region configuration
display stp region-configuration
Clear statistics about MSTP reset stp [ interface interface-list ]

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English