H3C S3600 Series User Manual

Operation Manual – Routing Protocol
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 4
OSPF Configuration
4-17
Operation Command Description
Enable ABR route
summary
abr-summary
ip-address mask
[ advertise |
not-advertise ]
Required
This command takes effect only
when it is configured on an ABR.
By default, this function is disabled
on an ABR.
Table 4-8 Configure ASBR route summary
Operation Command Description
Enter system view
system-view
—
Enter OSPF view
ospf [ process-id [ router-id
router-id ] ]
Required
Enable ASBR route
summary
asbr-summary ip-address
mask [ not-advertise | tag
value ]
Required
This command takes effect
only when it is configured on
an ASBR. By default,
summary of imported routes is
disabled.
4.6.3 Configuring OSPF to Filter Received Routes
Table 4-9 Configure OSPF to filter received routes
Operation Command Description
Enter system view
system-view
—
Enter OSPF view
ospf [ process-id [ router-id
router-id ] ]
Required
Configure to filter the
received routes
filter-policy { acl-number |
ip-prefix ip-prefix-name |
gateway ip-prefix-name }
import
Required
By default, OSPF does
not filter received
routing information.
 Note:
OSPF is a dynamic routing protocol based on link state, with routing information
hidden in LSAs. Therefore, OSPF cannot filter any advertised or received LSA. In fact,
the filter-policy import command filters the routes calculated by OSPF; only the
routes passing the filter can be added to the routing table.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English