Operation Manual – Routing Protocol
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 6
Route Capacity Configuration
6-3
Table 6-3 Disable automatic protocol recovery
Operation Command Description
Enter system view
system-view
—
Disable automatic protocol
recovery
memory auto-establish
disable
Optional
By default, automatic
protocol recovery is
enabled.
Note:
If automatic protocol recovery is disabled, the OSPF connection will not recover even
when the free memory exceeds the safety value. Therefore, take cautions when
disabling the function.
6.3 Displaying Route Capacity Configuration
After the above configuration, you can use the display command in any view to
display and verify the route capacity configuration.
Table 6-4 Display route capacity configuration
Operation Command Description
Display memory occupancy
of a switch
display memory [ unit
unit-id ]
Display the route capacity
related memory setting and
state information
display memory limit
You can execute the
display command in any
view.