H3C S3600 Series User Manual

Operation Manual – PoE-PoE Profile
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
PoE Configuration
1-6
1.7 Configuring the PD Compatibility Detection Feature
After the PD compatibility detection feature is enabled, the switch can supply power to
the detected PDs that do not conform to the 802.3af standard.
After the PoE feature is enabled, perform the following configuration to enable the PD
compatibility detection feature.
Table 1-6 Configure the PD compatibility detection feature
Operation Command Description
Enter system view
system-view
—
Enable the PD compatibility
detection function
poe legacy enable
Required
By default, the PD
compatibility detection
feature is disabled
1.8 Configuring PoE Over-Temperature Protection on the
Switch
If this function is enabled, the switch disables the PoE feature on all ports when its
internal temperature exceeds 65
0
C (149
0
F) for self-protection, and restores the PoE
feature settings on all its ports when the temperature drops below 60
0
C (140
0
F).
Table 1-7 Configure PoE over-temperature protection on the switch
Operation Command Description
Enter system view
system-view
—
Enable the PoE
over-temperature
protection feature on the
switch
poe
temperature-protection
enable
Required
By default, the PoE
over-temperature
protection feature is
enabled on the switch
 Note:
z When the internal temperature of the switch decreases to 65
0
C (149
0
F) below, but
60
0
C (140
0
F) above, the switch still disables the PoE feature on all the ports.
z When the internal temperature of the switch increases to 60
0
C (140
0
F) above, but
65
0
C (149
0
F) below, the switch still enables the PoE feature on all the ports.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English