H3C S3600 Series User Manual

Operation Manual – AAA-RADIUS-HWTACACS-EAD
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
1-37
1.5.4 Configuring HWTACACS Accounting Servers
Table 1-27 Configure HWTACACS accounting servers
Operation Command Description
Enter system view
system-view
—
Create a HWTACACS
scheme and enter its view
hwtacacs scheme
hwtacacs-scheme-name
Required
By default, no
HWTACACS scheme
exists.
Set the IP address and
port number of the
primary TACACS
accounting server
primary accounting
ip-address [ port ]
Required
By default, the IP address
of the primary accounting
server is 0.0.0.0, and the
port number is 0.
Set the IP address and
port number of the
secondary TACACS
accounting server
secondary accounting
ip-address [ port ]
Required
By default, the IP address
of the secondary
accounting server is
0.0.0.0, and the port
number is 0.
Enable the
stop-accounting message
retransmission function
and set the maximum
number of transmission
attempts of a buffered
stop-accounting message
retry stop-accounting
retry-times
Optional
By default, the
stop-accounting
messages retransmission
function is enabled and
the system can transmit a
buffered stop-accounting
request for 100 times.
Caution:
z You are not allowed to configure the same IP address for both primary and
secondary accounting servers. If you do this, the system will prompt that the
configuration fails.
z You can remove a server only when it is not used by any active TCP connection for
sending accounting messages.
1.5.5 Configuring Shared Keys for HWTACACS Messages
When using a TACACS server as an AAA server, you can set a key to improve the
communication security between the switch and the TACACS server.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English