H3C S3600 Series User Manual

Operation Manual – Login
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 3
Logging in through Telnet
3-1
Chapter 3 Logging in through Telnet
3.1 Introduction
You can manage and maintain a switch remotely by Telneting to the switch. To achieve
this, you need to configure both the switch and the Telnet terminal accordingly.
Table 3-1 Requirements for Telneting to a switch
Item Requirement
The management VLAN of the switch is created and the
route between the switch and the Telnet terminal is
available. (Refer to the Management VLAN Configuration
module for more.)
Switch
The authentication mode and other settings are
configured. Refer to
Table 3-2 and Table 3-3.
Telnet is running.
Telnet terminal
The IP address of the management VLAN of the switch is
available.
3.1.1 Common Configuration
Table 3-2 lists the common Telnet configuration.
Table 3-2 Common Telnet configuration
Configuration Description
Configure the command
level available to users
gging into the VTY user
terface
lo
in
Optional
By default, commands of level 0 are
available to users logging into a VTY
user interface.
VTY user
interface
configuration
Configure the protocols the
user interface supports
Optional
By default, Telnet and SSH protocol
are supported.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English