To Next Page

To Previous Page

Operation Manual – Multicast

H3C S3600 Series Ethernet Switches-Release 1510 Chapter 6 IGMP Configuration

6-13

Caution:

z Both the multicast routing protocol and the IGMP protocol must be enabled on the

proxy interface.

z You must enable the PIM protocol on the interface before configuring the igmp

proxy command. Otherwise, the IGMP Proxy feature does not take effect.

z One interface cannot serve as the proxy interface of two or more interfaces.

6.2.6 Removing the Joined IGMP Groups from the Interface

You can remove all the joined IGMP groups on all ports of the router or all the joined

IGMP groups on the specified interfaces, or remove the specified IGMP group address

or group address network segment on the specified interface.

Perform the following configuration in user view.

Table 6-7 Remove the joined IGMP groups from the interface

Operation Command Description

Remove the joined IGMP

groups from the interface

reset igmp group { all | interface

interface-type interface-number

{ all | group-address

[ group-mask ] } }

Optional

Caution:

After an IGMP group is removed from an interface, the IGMP group can join the group

again.

6.3 Displaying IGMP

After completing the above-mentioned configurations, you can execute the display

command in any view to verify the configuration by checking the displayed information.

H3C S3600 Series User Manual

Other manuals for H3C S3600 Series