H3C S3600 Series User Manual

Operation Manual – AAA-RADIUS-HWTACACS-EAD
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
1-28
1.4.6 Configuring to Support a Type of RADIUS Server
Table 1-17 Configure to support a type of RADIUS server
Operation Command Description
Enter system view
system-view
—
Create a RADIUS
scheme and enter its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS
scheme named "system"
has already been created
in the system.
Configure the switch to
support a type of RADIUS
server
server-type { extended |
standard }
Optional
1.4.7 Configuring the Status of RADIUS Servers
For the primary and secondary servers (authentication/authorization servers, or
accounting servers) in a RADIUS scheme:
When the switch fails to communicate with the primary server due to some server
trouble, the switch will turn to the secondary server and exchange messages with the
secondary server.
After the primary server remains in the block state for a set time (set by the timer quiet
command), the switch will try to communicate with the primary server again when it
receives a RADIUS request. If it finds that the primary server has recovered, the switch
immediately restores the communication with the primary server instead of
communicating with the secondary server, and at the same time restores the status of
the primary server to active while keeping the status of the secondary server
unchanged.
When both the primary and secondary servers are in active or block state, the switch
sends messages only to the primary server.
Table 1-18 Set the status of RADIUS servers
Operation Command Description
Enter system view
system-view
—
Create a RADIUS scheme
and enter its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS
scheme named "system"
has already been created
in the system.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English