To Next Page

To Previous Page

Operation Manual – FTP and TFTP

H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1

FTP and TFTP Configuration

1-12

II. Network diagram

Switch

NetworkNetwork

Switch

NetworkNetwork

Figure 1-3 Network diagram for FTP configurations

III. Configuration procedure

1) Perform FTP server–related configurations on the PC, that is, create a user

account on the FTP server with user name “switch” and password “hello”. (For

detailed configuration, refer to the configuration instruction relevant to the FTP

server software.)

2) Configure the switch.

# Log into the switch. (You can log into a switch through the Console port or by

Telneting to the switch. See the “Login” module for detailed information.)

<H3C>

Caution:

If available space on the Flash memory of the switch is not enough to hold the file to be

uploaded, you need to delete files from the Flash memory to make room for the file.

# Connect to the FTP server using the ftp command in user view. You need to provide

the IP address of the FTP server, the user name and the password as well.

<H3C> ftp 2.2.2.2

Trying ...

Press CTRL+K to abort

Connected.

220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user

User(none):switch

331 Give me your password, please

Password:*****

230 Logged in successfully

[ftp]

# Enter the authorized directory on the FTP server.

H3C S3600 Series User Manual

Other manuals for H3C S3600 Series